HAMILTON P7100 PUMP CAM

These pump cams are made in the USA in a non-union shop out of 8620 gas carburized steel. They feature the same lift as the OEM cam, but greatly shorten the number of degrees of total injection, while greatly increasing the amount of fill-time. This cam needs to be installed by qualified professionals only!

All of our injection components are for off-road use only. Buyer accepts all liability for their use. P-pumps in performance applications can occasionally stick the rack, which allows the pump to keep fueling until there is a loss of, air via an air-shutoff, until the mechanical limits of the motor are reached, or you run out of road. If the latter two are the case, expect to have help picking up pieces.......

In a 13mm pump, this cam injects a maximum of 5.681cc per degree at maximum velocity compared to 5.100cc per degree with a stock 180hp/215hp cam. Not only does it have a higher total velocity but it has a higher average across any .250" of the cam.

Later this year we will be releasing our V-2 and V-3. For comparison, the V-2 will max out at 5.784cc per degree and the V-3 will max out at 6.104cc per degree.